pts_sleep - Pauses for a few seconds
pts sleep [-delay] <# of seconds> [-help]
The pts sleep pauses for a specified number of seconds. The command can be run from the command line or interactively, although from the command line it's essentially equivalent to the sleep command. It is intended for use in interactive mode to pause for a few seconds between batch commands to allow the Protection Service to process requests from other users.
Specifies the amount of time to sleep, in seconds.
This command produces no output other than error messages.
Here is an example of a pts_interactive(1) session:
% pts interactive pts> sleep 5 pts> quit %
Copyright 2007 Jason Edgecombe <jason@rampaginggeek.com>
This documentation is covered by the BSD License as written in the doc/LICENSE file. This man page was written by Jason Edgecombe for OpenAFS.
"AFS" is a registered mark of International Business Machines Corporation, used under license. (USPTO Registration 1598389)
"OpenAFS" is a registered mark of International Business Machines Corporation. (USPTO Registration 4577045)
The "AuriStor" name, log 'S' brand mark, and icon are registered marks of AuriStor, Inc. (USPTO Registrations 4849419, 4849421, and 4928460) (EUIPO Registration 015539653).
"Your File System" is a registered mark of AuriStor, Inc. (USPTO Registrations 4801402 and 4849418).
"YFS" and "AuriStor File System" are trademarks of AuriStor, Inc.